zombie55's Product Reviews
Sort:

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.5)
› Quality
› Value
I have used the steamboy 2.1 clone for a week now and it vapes well. I got a thin o ring and placed on the thread for the top cap this makes positioning the air hole in front of the wick easy. the clone has 2 air holes opposite each other I have read reviews were people have closed the second air hole. I block off the second air hole but I did not improve the vape so I decided that I am happy with air holes open I decide to set the clone up the same as my original so it would help me compare them. The first difference I noticed was the original had a big enough wick hole to take 2.5mm 7*7 wire rope but the clone could only fit 2mm so I cut a piece of 2mm SS rope then covered the top 10mm with 2mm hollow ekowool then wrapped some 0.8*1 kanthal ribbon wire tightly around the ekowool as you don't have to worry about hotspots or shorts with this method so you can wrap the kanthal tight. I then tested the ohms on the coil which worked out to be 0.6 ohms which is the same ohm coil that my original steamboy has The clone vapes very well with this setup and the SS wire rope is great as you never get a dry hit even at low ohms. Since I have been using the SS rope and ekowool it has become my favourite way to vape So how can I sum it up well I think this is a great clone ok it has a slightly cheap fill to it compared to the original but it vapes really well. I would recommend using this as a single wick genesis as to use it as a double wick you would have to drill a fill hole in the top section. This is the same on the original if you go to steamboy site he recommend setting it up as a single wick. This little atty is a lovely rba to add to your collection so I would recommend it
Reviewed on
Glass + Brass 510 Drip Tips (2-Pack)
Glass + Brass 510 Drip Tips (2-Pack)

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.5)
› Quality
› Value
PROS
good value decent build quality
This driptips look good and mine arrived with no problems the glass is reasonably thick but they still could break if mistreated they are very comfortable to vape
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.7)
› Quality
› Value
PROS
good value decent build quality
This is a well machined driptip which fits a lot of my attie tightly it also looks great with the stillaire
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.5)
› Quality
› Value
PROS
good value works
These are great for changing the looks of your GT atties. Recommend
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.5)
› Quality
› Value
PROS
good value
This nano tank works well with all my GT clones and original I am happy with this item
Reviewed on