zombie55's Product Reviews
Sort:

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (2.0)
› Quality
› Value
PROS
decent chamber & afc
CONS
problems with base
This v42 has problems with the base the post holes which makes this dripper hard to use the holes are only on 1 side of the post so your coil legs have to be the right length also you have to pull the post legs upwards which is hard to do without a pair of pliers
Reviewed on
X2 RDA Rebuildable Dripping Atomizer
X2 RDA Rebuildable Dripping Atomizer

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.0)
› Quality
› Value
PROS
good value
CONS
need modding to work at it best
The x2 comes in a kamry box and has a drip tip included so it is reasonably good value for a 22mm dripper. The design is quite good the middle section screws to the bottom section and when fully screwed down the 2 airholes of the outer middle section where just about right with the 3 coils posts the easy way to describe there location is 11 & 5 on a clockface. The 4 different size air holes on the top inner section air all very small the largest is only 1mm so I had to drill the other smaller holes out to have better air flow I have been using it with dual 1.5mm air holes and a dual coil setup and it been vaping excellent overall I am happy with this purchase
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.0)
› Quality
› Value
PROS
good value good rba hybrid pin included
This is the aqua rba they are a good rba which can produce a great vape but they are a little harder to build than a kayfun also they do not hold as much eliquid. There are many different opinions on which one is the better rba I will not even try to tell you which is better all I will say I they are both good atties. One good tip for the aqua is to fill it upside down as it's a lot easier with this method and hold slightly more juice. The quality of this clone is good
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (4.5)
› Quality
› Value
PROS
good value
This is a nemesis mod most vapers know what the nemesis is all about it's one of the most used mech mods by vapers the build quality of this mod is good my threads all work fine they are not the smoothest threads I own but all catch fine and unscrew and screw without no problems. I cannot see any finish difference in this mod like the FT pictures showed all the tubes look the same and it works perfect I would recommend upgrading the button with magnets and it works better and can still sit upright without firing. The pins in this mod are made out of copper but there not silver plated which is fine but they may need keeping clean for it to fire at maximum voltage also the threads on this copper nemesis are compatible with the SS & brass nemesis FT sell so it's easy to mix and match
Reviewed on

zombie55
Verified

VERIFIED OWNER
  • JoinedAug 2013
  • Posts 760
  • Reviews 689
  • Kudos600
Overall   (5.0)
› Quality
› Value
PROS
well made good value smooth threads
This is a good clone of the taifun GS the threads are smooth and the parts are all machined well once you have found your best coil & wick setup these GS are a great little attie I recommend of these for anyones collection
Reviewed on