verynice's Product Reviews
Sort:

Stainless Steel Slim Money Clip
|
 verynice
Member
VERIFIED OWNER
- JoinedJun 2016
- Posts
1445
- Reviews
97
- Kudos1512
|
Overall
|
(5.0)
|
› Quality
|
|
› Value
|
|
1
of
1
people found the following review helpful
PROS
Definitely decent SS (303-304)
Not too hard, can be flexed to fit any size of roll
|
CONS
None
|
Great clip, took it on my latest 'journey' and it held the roll nice and tight after being adjusted to fit the bills. Not hardened too much but stiff enough to fit a fat roll.
Reviewed on
Was this review helpful to you?
Yes
/
No
|
|

HEAD HD-011-04 Hex Key Wrench / Allen Key Set (7 Pieces)
|
 verynice
Member
VERIFIED OWNER
- JoinedJun 2016
- Posts
1445
- Reviews
97
- Kudos1512
|
Overall
|
(5.0)
|
› Quality
|
|
› Value
|
|
1
of
1
people found the following review helpful
PROS
Pretty tough
Smallest sizes work w/ all the grubs I have here
|
CONS
none
|
Nice little set of allen keys that work with the smallest grubs I've seen in an RDA and have 2 smaller sizes than that to boot!
Reviewed on
Was this review helpful to you?
Yes
/
No
|
|

Kepler 510 Finned Heat Sink for Atomizers
|
 verynice
Member
VERIFIED OWNER
- JoinedJun 2016
- Posts
1445
- Reviews
97
- Kudos1512
|
Overall
|
(5.0)
|
› Quality
|
|
› Value
|
|
1
of
1
people found the following review helpful
PROS
adjustable pin
quality pins
good threads
|
CONS
Logos should be stamped not engraved :/ scrapes paint sometimes
|
I love it for my smaller atomizers like my Anima clone. I just wish the bottom didn't have engraved logos on it, they scraped some paint off my SXK s80 but have yet to do that to any other mods (so it could be the S80's paint is bad).
Reviewed on
Was this review helpful to you?
Yes
/
No
|
|

Convoy C8 LED Flashlight
|
 verynice
Member
VERIFIED OWNER
- JoinedJun 2016
- Posts
1445
- Reviews
97
- Kudos1512
|
Overall
|
(4.7)
|
› Quality
|
|
› Value
|
|
1
of
1
people found the following review helpful
PROS
Multiple modes, including a battery checking mode
Pretty bright
uses 18650s (of which I have plenty)
Can be modified with ease
|
CONS
A small shaving of solder was causing a short in the bottom cap, easily fixed
|
Not a bad flashlight, my dad needed something more substantial to carry when a maglite wasn't appropriate. At first I experienced issues caused by a small shaving of solder causing a short at the battery contact in the bottom cap but once that was removed I/my dad haven't had any issues since.
Reviewed on
Was this review helpful to you?
Yes
/
No
|
|
![]()
|
 verynice
Member
VERIFIED OWNER
- JoinedJun 2016
- Posts
1445
- Reviews
97
- Kudos1512
|
Overall
|
(4.7)
|
› Quality
|
|
› Value
|
|
1
of
1
people found the following review helpful
PROS
Adjustable TCR (actually works too)
Nice form factor
The battery cover isnt as bad as people say
The paint matches too with the latest runs
|
CONS
my kepler heatsink started rubbing off some paint immediately :/
|
Snagged this on sale and I am very satisfied. The adjustable TCR is quite easy to use and I've dialed it in for a number of wires (UD SS 316L clapton, Ni200, TI gr1/2) with ease. My Kepler heatsink rubbed off some paint immediately so I switched to a heatsink with a smooth surface on the bottom. I'll probably review this again in a few months after I beat it up a bit. If it lasts longer than my used pico then it's probably a good buy especially when on sale.
Reviewed on
Was this review helpful to you?
Yes
/
No
|