tiwi64's Product Reviews
Sort:

Avatar
tiwi64
Verified

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 352
  • Reviews 47
  • Kudos179
Overall   (5.0)
› Quality
› Value
PROS
Easy to build Small Well made
CONS
cheap insulator
Nice little RDA, excellent for stealth vaping. It is easy to wick and gives good flavour. Steel wool + mesh is perfect for this atty because vertical coils are so effortless to do on it and give much better flavour than cotton. Biggest con: The insulator is made out of cheap material and will melt easily so this RDA is good for just a little sub-ohming (>0.5 will be fine I guess). Apart from the insulator the build qualitiy is excellent, no burrs, threadings are fine, no wobble and wiggle anywhere. The drip tip fits tight and comes with double O-ring and in my opinion even the drip tip alone is worth the money.
Reviewed on

Avatar
tiwi64
Verified

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 352
  • Reviews 47
  • Kudos179
Overall   (5.0)
› Quality
› Value
PROS
everything
CONS
nothing
Outstanding genisis atomizer. Well machined. Superior flavour. Easy to build. After all those open draw attys I had over the last months it was a bit hard to get along with the _tight_ draw but now I'm used to it again. It's definitely not meant for huge clouds or lung inhaling. It's a very unhurried atomizer for peacefully puffing small but very flavourful clouds.
Reviewed on

Avatar
tiwi64
Verified

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 352
  • Reviews 47
  • Kudos179
Overall   (4.7)
› Quality
› Value
PROS
Cheap nice built looks good
CONS
switch/510 copper bar
Overally good. The 510 copper screw is not centered and has normal instead of counter threading. See my thread about the switch for more details. It will get its job done but could be better. Would buy again if and when I've found a way to rework/replace the switch/510 copper bar without to much effort.
Reviewed on

Avatar
tiwi64
Verified

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 352
  • Reviews 47
  • Kudos179
Overall   (5.0)
› Quality
› Value
PROS
nice machined
CONS
post holes are much smaller than they should be gap between deck and insulator gap between insulator and center post deck o-ring is too thick
Very good machined! No sharp edges, no burrs, no machine oil, threads run smoothly. The post holes are much smaller than the authentic ones (0.8mm wire will still fit easily but no claptons here). There are gaps between deck and insulator/insulator and center post where liquid is collecting. No 510 leakage so far but I better keep an eye on that. The o-ring on the deck has to be replaced on mine with a thinner o-ring. Without a second look it is not distinguishable from the authentic.
Reviewed on

Avatar
tiwi64
Verified

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 352
  • Reviews 47
  • Kudos179
Overall   (5.0)
› Quality
› Value
PROS
nearly everything
CONS
unintentional locking possible door magnet a bit weak well done but fugly engravings
Very nice mod and excellent machined as well. No sharp edges, everything sits thight and operates smoothly. Nearly zero internal resistance or as one would say: Hits like a trraaaaiiin. The single pair of door holding magnets are a bit weak but nothing to worry about.
Reviewed on