supervapez711's Product Reviews
Sort:

supervapez711
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 3
  • Reviews 11
  • Kudos9
Overall   (4.0)
› Quality
› Value
PROS
Well made 1A charge rate
CONS
None
This is a great charger for 18650s. It has LED charge indicators, and terminates at 4.18V..right where it should. I tested this charger with an ammeter on various wall warts and power banks. Make sure you have a solid 1A 5V adapter. This charger will work on the cheaper adapters..but the current draw will drop to around 600mA. If you have a good 1-2A source the charge current is right at 1A.
Reviewed on
Vaporesso SWAG II 80W VW APV Box Mod
Vaporesso SWAG II 80W VW APV Box Mod

supervapez711
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 3
  • Reviews 11
  • Kudos9
Overall   (2.2)
› Quality
› Value
PROS
-Inexpensive mod which accommodates 25mm attys.
CONS
-Too lightweight- made of plastic and feels cheap. -Battery cap is aluminum - durability in question. -Battery level indicator seems inaccurate. -Axon "chip" is sort of a joke. -Does NOT charge at 2A.
This mod is just OK really. I doubt it will hold up for very long and does not compete at all with the iStick Pico. I bought this mainly because Fasttech recently does not seem to be stocking any good, small single coil 22mm atomizers. I paired this with the 25mm bombus RTA (which I like). The mod works fine but all the functions and menu's are totally unnecessary. The main issues are the battery cap and the build quality. It definitely will not hold up. If you drop this thing on a hard surface it will most likely break. My pico seems virtually indestructible. Also, the battery cap is aluminum. If you charge your battery outside the mod "which you should" this cap is going to cross thread at some point. Out of the box the threading is rough. Finally the built-in charging is terrible. I tested with a USB voltage monitor using the Samsung QC protocol and standard USB. In both cases a dead battery only charges at 300mA. Not good. I will use this- but it will be a backup or something to leave in the car.
Reviewed on
Eleaf MELO 5 Replacement EC-S Coil Head (5-Pack)
Eleaf MELO 5 Replacement EC-S Coil Head (5-Pack)

supervapez711
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 3
  • Reviews 11
  • Kudos9
Overall   (5.0)
› Quality
› Value
PROS
Designed for DTL. No spitback/popping like other coil heads. Very cool, flavorful vapor. 0.6 Ohm coil. Great efficiency- 28W is perfect. The coil "mesh" will likely enhance the life of the coil head. (fewer wick hot spots)
CONS
Just wish they were a couple bucks cheaper.
For me this is the perfect coil head for the MELO. I would rather have my battery and juice last as long as possible instead of blowing clouds. This is the coil for it. I would stock up on these. Very disappointing when an item runs out of stock- permanently.
Reviewed on

supervapez711
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 3
  • Reviews 11
  • Kudos9
Overall   (5.0)
› Quality
› Value
PROS
Well built. Looks good and works nicely with the iStick Pico. Good selection of inexpensive coil heads for MTL or DTL. A lot of wattage options for juice efficiency, or clouds. *With proper coil*
CONS
Low juice capacity. You have to be VERY careful when removing the cap or glass piece. Can be easy to cross thread the cap ruining the device. Whistles a bit when inhaling. Spit-back at higher wattages. (minimal and can be greatly reduced with the right drip tip) Atomizer and Mod can get very hot. May limit the life of your Mod.
This is a good atomizer but I am not sure I would use it daily. I still prefer my Serpent Mini. The most important tip I have if you purchase this item is to get some of the .5 Ohm dual coil heads at the same time. They are optimal for the device and essential for DTL. The .75 Ohm included is only for MTL, and the spare .3 Ohm is simply wateful as far as wattage and also requiring a lower capacity higher amperage battery. The main reason I probably will not use this Tank is the juice capacity. The tank is basically half full "when full". Also removing the top and filling is a delicate procedure. Be careful of cross threading..and if removing the glass...use a plastic "spudger". You likely will not be able to remove it with your hand...and too much force may cause breakage in your hand.
Reviewed on

supervapez711
Verified

VERIFIED OWNER
  • JoinedMay 2016
  • Posts 3
  • Reviews 11
  • Kudos9
Overall   (5.0)
› Quality
› Value
PROS
Easy rebuild/wicking, multiple coil configurations available (twisted 28ga is perfect!), top fill, good air-flow, pairs perfectly with mini-mods.
CONS
None
I am so disappointed that this item was discontinued. I'm thankful that I bought multiples even though my first has lasted 2+ years. I have done an expansive search to find a similar product with no success. Hands down best single coil I have ever found. Bring it back!
Reviewed on