silverdollars's Product Reviews
Sort:

silverdollars
Verified

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 316
  • Reviews 57
  • Kudos64
Overall   (3.0)
› Quality
› Value
PROS
Good Build Quality Does Not Leak Great Flavour Easy Build Deck
CONS
Top (Filling ports) Silicone Gasket Poor Quality.
A really good RTA which is easy to build, fill and doesn't leak. Unfortunately the top cap's gasket/seal swells after the tank has been used for around 8 - 10 days. This causes the seal to expand into the filling ports and when the top cap is removed it tears the seal and you have to change it. You do get a spare seal with the RTA but in less than a month you will need replacements... This problem has also been reported on Geekvapes own site so it's not an isolated incident. It happened on mine after 8 days with one of the stock coils which was supplied with the RTA, my settings were 0.35 ohm at 30 watts so it wasn't having to work hard, I did get great flavour and zero dry hits so it's not all bad. IMHO Geekvape should manufacture the seal from a higher grade of silicone and until they do supply replacement seals either free or at a reduced cost to their customers. I know of another 6 people who have had the identical fault on their Zeus dual RTA.
Reviewed on

silverdollars
Verified

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 316
  • Reviews 57
  • Kudos64
Overall   (5.0)
› Quality
› Value
PROS
Price Looks Build Quality 100's of Different Coils Available No Leaks Great Airflow
CONS
Maybe the air adjustment - depends...
I Usually use the Melo 3 but thought I would try this one because of the "Press Fit" Fault on the Melo tanks. I was very surprised at how good it was, No Leaks even without the airflow band or even when filling. I always have the airflow set to maximum so I don't use the cheap silicone air adjustment band which is the only part of the kit I don't like. The base of this tank is 1 piece of Stainless steel where as most other tanks have two pieces "Press fitted" together with an adjustable airflow ring inbetween which generally splits in two if dropped, and it never really fits together again properly. The Melo 3 and Kanger aerotank series all had the same fault... Good 24mm solid tank :o)
Reviewed on

silverdollars
Verified

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 316
  • Reviews 57
  • Kudos64
Overall   (3.5)
› Quality
› Value
PROS
thickness choice of color
CONS
not great insulators oversized center hole oversized diameter
These are really good for preventing your tanks from marking the top of your mod and for relieving the pressure on the center pin contact. They don't insulate your mod from the atomizer heat wise unless you use a few together, and even then not that much... Good having a choice of colors to match the mod and tank. When used with a 22mm tank they protrude from the join by about 0.5mm and with the center hole being a bit too big they need care to center when tightening.
Reviewed on

silverdollars
Verified

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 316
  • Reviews 57
  • Kudos64
Overall   (5.0)
› Quality
› Value
PROS
Design Color Seals Price
CONS
510 size bit over
Really good Drip tips very well made and seal very well if not too well on some atomizers,they are too tight on some tanks but just a good fit on the majority.
Reviewed on

silverdollars
Verified

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 316
  • Reviews 57
  • Kudos64
Overall   (3.0)
› Quality
› Value
PROS
Good fit for 22mm mods Quality fixing pad
CONS
Thin (fence) bracket at the bottom weak
It a good stand for in your car or workstation, but the bottom fence bracket is fairly weak where it is bent from the back, be careful unwrapping when it arrives and also when sticking it to it's final resting place! It fits my Aspire CF-Mod with Kangertech Megatank really well with hardly any rattle and the £m fixing pad is very secure.
Reviewed on