shopping cart empty
phlegmor's Product Reviews
Sort:
Coppervape NarCa Styled RDA Rebuildable Dripping Atomizer
Coppervape NarCa Styled RDA Rebuildable Dripping Atomizer

phlegmor
Member

VERIFIED OWNER
  • JoinedNov 2014
  • Posts 652
  • Reviews 295
  • Kudos750
Overall   (3.5)
› Quality
› Value
5 of 7 people found the following review helpful
This is much easier to use than the Narda. Coiling is done and perfect in mere seconds, the chamber is also much more forgiving when it comes to different builds. The draw is quite noisy but the typical Narda whistle, while present with certain builds and positioning, can be totally eliminated (3mm coils were better than 2.5mm coils for me, but coil height makes a difference as well. You can build hotter than in the Narda. About this SKU: Build quility is great, but the top cap does not go down all the way to the base and will leave a ~0.5mm gap, which is quite visible and almost makes me want to buy another SKU. The optional PEI cap leaves an even bigger gap. The O-Rings are not great.
Reviewed on Was this review helpful to you? Yes / No
SXK SOLO Styled RDA Rebuildable Dripping Atomizer
SXK SOLO Styled RDA Rebuildable Dripping Atomizer

phlegmor
Member

VERIFIED OWNER
  • JoinedNov 2014
  • Posts 652
  • Reviews 295
  • Kudos750
Overall   (5.0)
› Quality
› Value
3 of 3 people found the following review helpful
It's kind of like the Narda. It has almost Narda flavour, no Narda whistle (it's not completely silent though) and it's almost as tough to find a good build for it as it is for the Narda. If you like builds with complicated wires, try an ID of 2.5mm to give the air some room to try and cool your coil down again. Better (for me) were single wire parallel coils with thinner wire (AWG 26 or 27) and bigger IDs (3-3.5mm). The stainless steel top cap does not touch the positive block, so there will be no shorts. The YFTK PEI and PEEK top caps fit this atomizer.
Reviewed on Was this review helpful to you? Yes / No
Teflon 510 Drip Tip
Teflon 510 Drip Tip

phlegmor
Member

VERIFIED OWNER
  • JoinedNov 2014
  • Posts 652
  • Reviews 295
  • Kudos750
Overall   (5.0)
› Quality
› Value
3 of 3 people found the following review helpful
You can use this to make your Velocity RDA look like you're using the chuff tip while you still get all the flavour. Ok, the inner bore could be a just bit wider for that purpose. That slightly rough teflon finish provides a good mouthfeel. I like it.
Reviewed on Was this review helpful to you? Yes / No
Pitbull Styled RDTA Rebuildable Dripping Tank Atomizer
Pitbull Styled RDTA Rebuildable Dripping Tank Atomizer

phlegmor
Member

VERIFIED OWNER
  • JoinedNov 2014
  • Posts 652
  • Reviews 295
  • Kudos750
Overall   (5.0)
› Quality
› Value
3 of 3 people found the following review helpful
I bought this little tank to use with the Atto mod in 18350 mode, but I have not found the right balance between agressiveness (2mm AWG30 coil) and smoothness (2.5mm AWG26 coil) yet that won't also stress those little batteries too much. What the Le Zephyr is to the Le Mirage, this little atomizer is to the Split atty. The first two are just easier to build and use and taste phenomenal. The latter two are smaller, look great and are more interesting. This particular SKU is build flawlessly by the manufacturer. Highly recommended if you look for something small or something to tinker with. 8)
Reviewed on Was this review helpful to you? Yes / No
ULTON Salix Styled MTL RDA Rebuildable Dripping Atomizer
ULTON Salix Styled MTL RDA Rebuildable Dripping Atomizer

phlegmor
Member

VERIFIED OWNER
  • JoinedNov 2014
  • Posts 652
  • Reviews 295
  • Kudos750
Overall   (5.0)
› Quality
› Value
2 of 2 people found the following review helpful
PROS
- truly silent draw - not exceptionally quiet like the Le Concorde but truly, totally silent - domed top cap - for 3mm ID coils the cutout for your coiling rod provides the perfect coil positioning, no guess work or tinkering needed.
CONS
- gimmicky post system only has cons and no pros - you have to replace the grub screws with better, longer ones, they are the worst I have seen since 2013 and almost don't work at all.
There are many excellent restricted DTL RDAs out there and while this one isn't bad with the DTL cassette I will concentrate on reviewing it as a MTL RDA. The cassette with the biggest round hole provides just the perfect draw resistance for me. It's a nice semi-loose MTL draw comparable to the Hussar RTA with the 2mm pin. The Le Concorde is just a bit more open with the single hole. The draw is absolutely silent and smooth. You should use a MTL drip tip though with a smaller ID. The two cassettes with the tiny round holes have a real cigarettelike draw and more flash than the bigger round hole. I just put in a 5 wrap 3mm coil of VV Superfine MTL fused clapton Kanthal wire and it vapes very nicely unregulated. 4 wraps will probably be even a bit better in being more responsive and providing a bit more vapor. I recommend this atty highly.
Reviewed on Was this review helpful to you? Yes / No