mpekas's Product Reviews
Sort:

mpekas
Verified

VERIFIED OWNER
  • JoinedJun 2013
  • Posts 11
  • Reviews 8
  • Kudos6
Overall   (4.7)
› Quality
› Value
PROS
Soft, easy to feel clicky buttons Nice screen brightness Very nice finish
CONS
Slight gap on the sleeve Doesn't show the volts left in the battery Doesn't show the volts when firing Manual might be from a different device since it's entirely wrong Resistance detection is slightly skewed(shows -10%Ω)
Overall, a very good surprise with fully functional TC and the ability to use ss/Ti/etc wires. The sleeve gave me a scare since it looked very dirty wherever i touched it, but whatever that was it went away on it's own after using it for a couple of hours.
Reviewed on

mpekas
Verified

VERIFIED OWNER
  • JoinedJun 2013
  • Posts 11
  • Reviews 8
  • Kudos6
Overall   (4.5)
› Quality
› Value
PROS
-Works with all my mechs and even some regulated mods. -Design
CONS
-Price: it is a bit expensive for what it does.
It doesn't look like 600lumens, but it's pretty bright and has a glow-in-the-dark o-ring as well. It works at various voltages but doesn't seem to work with any of my regulated devices that don't support setting the volts directly - zeromod(from fasttech) and Dicodes Dani. Works fine with a provari 2, anywhere from 2.9-4.5V.
Reviewed on
Stainless Steel Double Wall Vacuum Water Bottle Insulation Cup (500ml)
Stainless Steel Double Wall Vacuum Water Bottle Insulation Cup (500ml)

mpekas
Verified

VERIFIED OWNER
  • JoinedJun 2013
  • Posts 11
  • Reviews 8
  • Kudos6
Overall   (4.7)
› Quality
› Value
PROS
Keeps liquids cold for a looong time Looks like a water bottle Very nicely sealed cap
CONS
Coloured ones scratch very easily Visible seam at the bottom Opening is a bit small for most ice cubes
Very nicely built and keeps contents cold/warm for several hours - my coffee still had ice cubes ~10 hours later.
Reviewed on

mpekas
Verified

VERIFIED OWNER
  • JoinedJun 2013
  • Posts 11
  • Reviews 8
  • Kudos6
Overall   (2.2)
› Quality
› Value
PROS
Ergonomic Cuts cotton/silica/mesh better than any scissors i've tried Fits in small toolboxes
CONS
Not stainless steel, in fact it feels like iron Red/Brown Rusty goodness!
Very useful tool for any rebuildable atomizer toolbox - cuts cotton, silica and mesh with ease. I'd pay 3 times as much for one with stainless steel blades - rusty wicks are no good!
Reviewed on

mpekas
Verified
  • JoinedJun 2013
  • Posts 11
  • Reviews 8
  • Kudos6
Overall   (2.5)
› Quality
› Value
PROS
Spring loaded positive post Nicely sized 'well' for juice storage
CONS
Can't be fully dissassembled Tiny wire holes Wire hole placement
It looks(internally) and functions like the A7ss rda, with a few differences. It's center post(510 positive pin) is spring loaded and the base is removable but there's no apparent way to dissassemble anything below the base plate. The wire holes on the posts are VERY small and poorly aligned, so the coil replacement is pretty damn hard. Replacing the grub screws with normal screws makes it a lot easier - i even managed to use it with dual coils!
Reviewed on