shopping cart empty
hammuh's Product Reviews
Sort:

hammuh
Member

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 24
  • Reviews 66
  • Kudos7
Overall   (5.0)
› Quality
› Value
4 of 4 people found the following review helpful
The black box 1:1 clones are all amazing IMO. This comes with a nicely machined Sat22 clone along with a bag of supplies and two extra tank sections. The tank sections are clear and frosted plastic, as well as stainless steel for tank cracking liquids. Unfortunately, there is no glass section as claimed in the item description, but that's not a big deal for me. I am not a genesis expert but managed to pull off a build that works decently. Used 400 mesh and a 5/6 wrap of 28 gauge wire. I won't comment much else on the taste since I'm a novice at genesis builds. I will note, however, that the draw is very tight -- close to how I remember cigarettes. The Sat22 is for mouth-to-lung inhalers, not lung hitters. The Sat22 is kind of a pain to fill and requires a needle nose bottle or syringe. Once filled it is quite good at keeping in liquid and does not leak easily. I think this is due to the step-like design which means you should be able to tilt or even lay the atomizer on its side without leaking through the air holes. One thing to note is to be careful when disassembling the atomizer for cleaning. I broke a tiny o-ring on the 510 pin (or perhaps it was broken upon arrival), and another o-ring in the center shaft popped out and I was unable to figure out how to get it back in. The atomizer seemingly works fine without these two o-rings, so not sure what the deal is.
Reviewed on Was this review helpful to you? Yes / No

hammuh
Member

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 24
  • Reviews 66
  • Kudos7
Overall   (4.7)
› Quality
› Value
3 of 3 people found the following review helpful
Knew nothing about this and ordered it. I had to look at YouTube videos to figure out how to use it. After figuring out how to disassemble I was greeted by a post-less deck. You need to trim wires to the correct length before installing. This was hard for me. Because of that I will only recommend this RTA to people who have a lot of experience with rebuildables. The build deck is attached through a latching system. I highly recommend looking at videos to see how this works. I have never seen this in an RTA before. Another tricky thing is that when you screw the RTA into a mod, you will need to turn a bit hard so that the build deck "latches" into place. The RTA will not work properly unless it is latched or locked, causing dry hits. This is a bottom fill RTA. Simply unscrew the bottom and fill the tank. Otherwise the RTA looks expensive. Also the taste is very good. Kind of restricted as is typical of high end RTAs, but this doesn't seem aimed at the MTL crowd. Once I figured out its quirks I started using it regularly.
Reviewed on Was this review helpful to you? Yes / No
Dvarw MTL V2 Styled RTA Rebuildable Tank Atomizer
Dvarw MTL V2 Styled RTA Rebuildable Tank Atomizer

hammuh
Member

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 24
  • Reviews 66
  • Kudos7
Overall   (5.0)
› Quality
› Value
2 of 2 people found the following review helpful
I have been a MTL fan since trying the Kayfun Lite and Russian clones. For a long time I was loyal to the Kayfun series and kept buying the newer ones. I felt let down by most, including the Kayfun 5 and Prime. Too complicated with many things to adjust, like airflow rings and turning juice flow control. If you didn't dial things in correctly you would get dry hits, gurgling, or leaking. The Kayfun Lite 2019 was okay but I felt that there must be better out there. I saw that the Dvarw was getting rave reviews. The Dvarw comes with various tanks for changing the look and size. Although this is a "no name" clone the quality seems as good as brands like SXK, YFTK and Ulton. I noticed no problems with my set. I was impressed that it came with so many parts for a very reasonable price. This is a bargain. I like that the Dvarw is simply in design. Some might say "old school." You adjust the airflow by changing an insert. And there is no need to worry about adjusting juice flow control or other complicated non-sense. Most of the newer MTL RTAs became too complicated and thus suffered in usability. The Dvarw keeps it simply and works well. I have no issues with 50/50 PG VG despite the lack of liquid flow control. The wick stays wet. Some people hate bottom filling but I don't mind it. Even if a RTA has top fill you will need to close juice flow control which is an extra step anyway. Overall I highly recommend this RTA. The taste rivals the old Kayfuns and the usability is better. This has quickly become my most beloved RTA.
Reviewed on Was this review helpful to you? Yes / No

hammuh
Member

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 24
  • Reviews 66
  • Kudos7
Overall   (5.0)
› Quality
› Value
1 of 1 people found the following review helpful
I have been a MTL fan since trying the Kayfun Lite and Russian clones. For a long time I was loyal to the Kayfun series and kept buying the newer ones. I felt let down by most, including the Kayfun 5 and Prime. Too complicated with many things to adjust, like airflow rings and turning juice flow control. If you didn't dial things in correctly you would get dry hits, gurgling, or leaking. The Kayfun Lite 2019 was okay but I felt that there must be better out there. I saw that the Dvarw was getting rave reviews. I like that the Dvarw is simply in design. Some might say "old school." You adjust the airflow by changing an insert. And there is no need to worry about adjusting juice flow control or other complicated non-sense. Most of the newer MTL RTAs became too complicated and thus suffered in usability. The Dvarw keeps it simply and works well. I have no issues with 50/50 PG VG despite the lack of liquid flow control. The wick stays wet. Some people hate bottom filling but I don't mind it. Even if a RTA has top fill you will need to close juice flow control which is an extra step anyway. Overall I highly recommend this RTA. The taste rivals the old Kayfuns and the usability is better. This has quickly become my most beloved RTA.
Reviewed on Was this review helpful to you? Yes / No

hammuh
Member

VERIFIED OWNER
  • JoinedApr 2014
  • Posts 24
  • Reviews 66
  • Kudos7
Overall   (5.0)
› Quality
› Value
1 of 1 people found the following review helpful
Knew nothing about this product but ordered it anyway. The S-Tank seems intended for restricted draws, but not necessarily MTL. Rotate the bottom ring for airflow. Rotate the top cap for filling. Works well so far. Taste is very good if you are okay with a restricted draw like Kayfun 5. No real complaints. This made it to my regular rotation.
Reviewed on Was this review helpful to you? Yes / No