it's identical 1:1 RDTA V1 Optional upgrade parts if needed.. velocity dual post deck sku 3893800 3ml top cap sku 4463901 AFC ring sku 4137700 Glass tank sku 2020103 O-ring for glass tank ø22mm x1.5 sku 4624900 O-ring for chimney ø9mm x1.5 sku 4625001 O-ring for bottom base ø20mm x1 sku 4616901 O-ring for deck ø11mm x1 and ø7mm x1 post screw is M2.5 x3mm sku 3981606 Allen key is 1.25mm sku 2336101

very nice vape very easy to rebuild I using 26AWG SS316 wire ø3mm 6wrap it came with one pre-coil ready, extra wire and cotton. it may not durable enough for long term rebuild should order the 5-pack value pack for better deal.

I only carry it to go on my daily base recently because its size and weight. I like the 0.5ohm Cubic SS coil with it. performing very well with MaxVG juice. airflow is good enough for MTL style. real 2100mAh long run battery built in. cheap starter setup. many different Cubic head you can choose.

just need to filing down little bit off the chamber to align the juice hole. but couldn't wrap any bigger than ø3mm coil because the gap between 2 post were tight. great airflow and juice flow for single coil and sub ohm.

it came very fast within 14 days shipped. nice packaging with can case i already adjust the positive post of my tank as much as I can before put it on but it still get short... so I need to file down very much 510 (-) on it because the positive post was too short , it's came almost flat with the negative 510 and it will suck in when you push it because the soft seal. highly recommend not use it on hybrid mod in the first time....until you did some modifications.... you need to put it on the tank/ RDA first then screw it on the mod. otherwise you will take time to deal with that spring bearing...it's fun to spring afterwards...good luck