shopping cart empty
ecotack's Product Reviews
Sort:
510 Heat Dissipation Heat Sink for Atomizers
510 Heat Dissipation Heat Sink for Atomizers

ecotack
Member

VERIFIED OWNER
  • JoinedOct 2016
  • Posts 2
  • Reviews 4
  • Kudos2
Overall   (3.7)
› Quality
› Value
1 of 1 people found the following review helpful
PROS
Cheap for a copper heat sink. Good smooth finish. Threads are good and clean.
CONS
Appears identical to SKU: 2639801, which is cheaper
I bought this and SKU: 2639801. Both look identical, but the other one is cheaper. May be there is some difference, but I can't see it.
Reviewed on Was this review helpful to you? Yes / No
5mm*2mm Brass Pillars for Electronics DIY (2-Pack)
5mm*2mm Brass Pillars for Electronics DIY (2-Pack)

ecotack
Member

VERIFIED OWNER
  • JoinedOct 2016
  • Posts 2
  • Reviews 4
  • Kudos2
Overall   (4.0)
› Quality
› Value
PROS
Easy to solder. Made a good contact.
CONS
Two is not enough. Need bigger packs. Postage likely cost more than the pillars.
Would be better to have bigger packs (the 10 pack is sold out at ATM). A range of sizes would be nice.
Reviewed on Was this review helpful to you? Yes / No
4* AMC7135 2-Group 3/5 Modes LED Flashlight Driver (Nanjg 101-AK-A1)
4* AMC7135 2-Group 3/5 Modes LED Flashlight Driver (Nanjg 101-AK-A1)

ecotack
Member

VERIFIED OWNER
  • JoinedOct 2016
  • Posts 2
  • Reviews 4
  • Kudos2
Overall   (4.7)
› Quality
› Value
PROS
Simple single cell driver. Comes with wires. Standard 17mm.
CONS
Could have included a battery spring. Instructions for modes groups was wrong.
I needed a simple 3 mode group driver, but shorting the 2 pins on the IC, as instructed, didn't work. I found that if on low setting the light flashed after a few seconds, double clicking the switch after the flash changed the mode groups.
Reviewed on Was this review helpful to you? Yes / No
510 Finned Heat Sink for Atomizers
510 Finned Heat Sink for Atomizers

ecotack
Member

VERIFIED OWNER
  • JoinedOct 2016
  • Posts 2
  • Reviews 4
  • Kudos2
Overall   (5.0)
› Quality
› Value
PROS
Cheap for a copper heat sink. Smoothly finished. Threads are good and clean.
CONS
None
Appears to be identical to SKU: 2471100, but cheaper. Using this for an LED heat sink, so as to its intended use I can not comment.
Reviewed on Was this review helpful to you? Yes / No