shopping cart empty
dsobelman's Product Reviews
Sort:
TP-Link TL-WR841N 2.4G 300Mbps WiFi Wireless Router
TP-Link TL-WR841N 2.4G 300Mbps WiFi Wireless Router

dsobelman
Member

VERIFIED OWNER
  • JoinedMar 2014
  • Posts 3
  • Reviews 9
  • Kudos0
Overall   (3.0)
› Quality
› Value
4 of 4 people found the following review helpful
PROS
cheap
CONS
Chinese only. No English firmware avail from tp-link. not open ddwrt supported.
there is no 841n v11 listed on tp-link site, product doesn't match any 841n or 841nd on the site. but once I tracked down a firmware file for it, it lists it as 842n V4 (chinese only) and matches pictures for 842n (chinese only). If you can read chinese, GREAT!! lol. I can't so figuring out these settings is going to be a major *CENSORED* :P
Reviewed on Was this review helpful to you? Yes / No
Nemesis Style Mechanical Mod
Nemesis Style Mechanical Mod

dsobelman
Member

VERIFIED OWNER
  • JoinedMar 2014
  • Posts 3
  • Reviews 9
  • Kudos0
Overall   (3.7)
› Quality
› Value
1 of 1 people found the following review helpful
PROS
decent quality switch & connector sections allow use of flat/button, protected/unprotected batteries. lock ring
CONS
silver under locking collar, should be purple.
At first I hated it, but after figuring out I needed to attach atty with 510 connector off, tighten positive contact, put in 510 connector, then screw on button/switch last, is best of the 3 cheap clones I ordered.
Reviewed on Was this review helpful to you? Yes / No

dsobelman
Member

VERIFIED OWNER
  • JoinedMar 2014
  • Posts 3
  • Reviews 9
  • Kudos0
Overall   (4.7)
› Quality
› Value
1 of 1 people found the following review helpful
PROS
Solid ICSP programmer Variable vdd I2c eeprom programming Uart tool Logic tool Programmer to go (has the eeproms for it unlike some clones)
CONS
None
All features work. Tested them all! Has the two 512 eeproms needed for programmer to go, and can be upgraded just as the original pickit2. Clean solid unit,(button not deformed like in the picture). Took it apart, board is solid clean work. Has short protection! (Hooked it up wrong and got "voltage error" warning. Very nice.
Reviewed on Was this review helpful to you? Yes / No
Sony US18650VTC3 18650 1600mAh 3.7V Rechargeable Li-ion Batteries (2-Piece)
Sony US18650VTC3 18650 1600mAh 3.7V Rechargeable Li-ion Batteries (2-Piece)

dsobelman
Member

VERIFIED OWNER
  • JoinedMar 2014
  • Posts 3
  • Reviews 9
  • Kudos0
Overall   (5.0)
› Quality
› Value
PROS
great output
CONS
none
these surge well above 30, melted keystone battery sled with shorted box mod, battery held up great and still ticking. (I've measured 50 amps through test setup on a keystone sled and it didn't melt so it must have been a hell of a surge. :P) As batteries are no longer air mail, it took just over 60 days to arrive.
Reviewed on Was this review helpful to you? Yes / No
Switch Magnets for Nemesis Mod (10-Pack)
Switch Magnets for Nemesis Mod (10-Pack)

dsobelman
Member

VERIFIED OWNER
  • JoinedMar 2014
  • Posts 3
  • Reviews 9
  • Kudos0
Overall   (4.2)
› Quality
› Value
PROS
cheap conductive strong
CONS
none
fits in nemesis perfectly. ALL magnets sized for nemesis can and will break if mishandled (let them slam together). trick is slide them apart.. I use for nemesis mods, other diy, and battery charging. out of 20, me and my daughter broke 5 in two weeks playing with them lol.
Reviewed on Was this review helpful to you? Yes / No