Mixing juices manually I got tired by the technocrats EU rules, it is silly to mix base first then juice and calculate the contents manually. And Chinese shops sell literally no juices. So we are reliant on overpriced western bottles. I tried this upper end series of Liqua via Fasttech and I'm happy. The tea flavor is there, luckily without much milk which is a lunacy from tea perspective anyway. Tried also shake and vape and it was good.

Used it for years.. Nothing is so tiny like this micro grip. Battery is shown in incorrect way - when 50% is displayed, battery is close to death. "Thanks" to the shape on the top, you can fit only 22mm. Wish the silly raised corner wasn't there.

Galaxies RTA flavor: excellent as their RDTA, bit less resolution bottom floods:none spits:minimal top leaks:none juice filling: top after unscrew, ultrawide holes juice consumption: on higher side airflows: tight, very good screw system - never need to readjust after unscrewing etc mechanics: very hard to unscrew top fill platform: one directional coil mounting:(, normal flat screws, screws from the side:( = hard to operate with the jig extras: can rotate platform block with airflow holes to change airflow configuration, nice tip, size between Berserker and Ares, 3ml much usable than 2ml Galaxies RDTA: flavor: excellent clean taste, +10% better with wider tip bottom floods:none spits:minimal with wider tip, frequent with thin tip top leaks:yes the airflow holes can get wet especially when topfilling manually, but hey you can flip the atomizer, this is not an issue juice filling: via 510 squonk, drip fill or topfill via automatically closed hole juice consumption: high airflows: good combinations possible, but very hard to read and it will alter after every opening of the top mechanics: weird to take out the top and put it back, middle o-ring gets devastated quick platform: one directional coil mounting:(, shitty rare H1.3 screws, screws from the side:( = hard to operate with jig, extra airflow screws which tend to screw back, holes to hold the jig and center coil easily, nice but again, screwing is hard with a jig placed on it extras: Topfilling hole doesn't work with all bottles and can get you wet. 3 systems - RDA,RTA and squonk in 1 device. Squonking mechanism works well and is recommended. Wicking is not easy, stuffing it to the holes is rather difficult.

hard to remove from the holder rubber handles separate from the sticks easy overall not sure if this is better than multi size stick.

Very good flavor. Doesn't leak even when bottom up. Platform is very difficult. Hex 1.3mm is very rare. Therefore stay at home. Hard to screw, super ultra hard and slow to wick. Filling through hole almost breaks bottle. At least easy to review status inside and can change coil or cotton without any twist. Interesting first thoughts.