[dismiss] Holiday closure: from January 27th to February 7th, 2022. Shipping and support will resume on February 8th, 2022. (details)
FastTech wishes you and yours a safe and prosperous year of Tiger 🐱.
Vostock's Product Reviews
Sort:
EMI Shielding Conductive Adhesive Copper Foil Tape (3mm*20m)
EMI Shielding Conductive Adhesive Copper Foil Tape (3mm*20m)

Vostock
Member

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 19250
  • Reviews 361
  • Kudos21739
Overall   (4.5)
› Quality
› Value
1 of 2 people found the following review helpful
PROS
works
CONS
tends to unravel
GOOD STUFF.. multitude of uses where conductivity or tightning of threads is needed. Tacky rather than sticky so tends to unravel, keep in zip lock bag-no problem. Y'know the deal decent product,decent price always handy for vapers so y'know....
Reviewed on Was this review helpful to you? Yes / No

Vostock
Member

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 19250
  • Reviews 361
  • Kudos21739
Overall   (4.2)
› Quality
› Value
PROS
decent product cheap as chips
CONS
some colours bit naff
buck a tank.. who'll give me a buck a tank, selling for a buck a tank, who wants 'em roll up roll up YES it works out at a dollar a tank..possibly not pyrex, they seem coloured glass rather than coated, nice deeper colours(ok couple of the colours might not suit your personal taste but hey better purple glass than no glass) they fit both pro and aerotanks fine without leaks. Individually boxed all arrived intact, If you use the older kanger tanks..snap 'em up while you can..great deal
Reviewed on Was this review helpful to you? Yes / No

Vostock
Member

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 19250
  • Reviews 361
  • Kudos21739
Overall   (4.0)
› Quality
› Value
PROS
ok with a bit of fettling
CONS
bit temperamental
OK the challenge for me was..how good can a 10dollar mod be? Not the latest design but then it wouldn't be at this price would it? My first side fire button so don't know if these issues apply to others. Anyhoo ..... plating seems ok-ish..bottom cap bit crunchy but wears in with use..you will need to trim/swap the bottom spring, I think it's from a tank chassis way way too stiff/strong for the job. Top cap bit crunchy again only on 1st use. Button needs disassembly and sharp internal edges smoothed...be very careful there's a tiny ball bearing in there..check youtube for disassembly vids..it really is worth checking before you take it apart. Once re-assembled be careful, batt will push upwards(this is why spring needs attention)..top cap will push down..to much 'push' either direction and switch will misalign with hole in tube and be reeally difficult to use...tinker about a bit of a balancing act to find the 'sweet spot' and when you do it's ok. Turn button right to lock BACK to centre to fire..don't turn left to try to lock it can be difficult to get back to centre. I find as I'm vaping the button creeps round to lock position which can be a bit annoying but it might just be the way I press on button. Would prefer different spring and an easier to grip button. Now is it worth 10bucks? if your prepared to put in a bit of work it can work ok..not brilliant but ok..not the best low cost mod on FT ?(that's the 'bonefire' in my book..but it does work, is cheap, and an ok side-fire if you don't mind a 'little project' get one.
Reviewed on Was this review helpful to you? Yes / No
DIY Spring-loaded Firing Button for Mechanical Mod
DIY Spring-loaded Firing Button for Mechanical Mod

Vostock
Member

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 19250
  • Reviews 361
  • Kudos21739
Overall   (4.0)
› Quality
› Value
1 of 2 people found the following review helpful
PROS
nice enough piece
CONS
none really
Nice enough piece, seems well made and robust enough, nice and clicky, not mounted it in a mod yet so can't comment on actual 'in use' performance but as I say seems good quality and nice price.
Reviewed on Was this review helpful to you? Yes / No

Vostock
Member

VERIFIED OWNER
  • JoinedJul 2014
  • Posts 19250
  • Reviews 361
  • Kudos21739
Overall   (3.7)
› Quality
› Value
PROS
does what it says
CONS
slightly more tinny?
OK piece does the job, nice and cheap, not sure if its same supplier as previously, plating seems a bit tinny..but yup does the job and you really do need one for any protanks you have and for the stash...buy 'em while you can.
Reviewed on Was this review helpful to you? Yes / No