Follows the Hellfire design for airflow, like the Strike and Maverick, with a smaller chamber. So dont go too low with resistance, the vape and the atty heat up easily. For true mtl it is one of the best drippers/squonkers with side airflow, but still not as good as MTL tanks like Taifun GTR, Dvarw, Tripod, etc.

Do what they should, refill tanks and RDTA with very thin fillholes. Satisfied

Well its ok, no real flaws, but less quality. The posts on the deck, the screws, outside diameter.. all is different from authentic, only the standard 810 driptip is exchangeable.

One of the best clones i know, everything fits and is interchangeable with original Simple, clean, classy look and feel Typical dual coil vape, with the good flavor of a 22mm atty Easy wicking, mono coil reduction works very good. The juice well is small, better use it for squonking

The most positive for me is the dense creamy vapor it produces, the most negative the noisy airflow, with some whisteling with airflow fully open. The deck is simple in a good way, coils are very easy to mount, especially any kind of claptons. The BF pin ends in a flat hole on the bottom of the deck and the airholes going upwards from inside to outside of the deck, which gives me a good squonking experience. Vape slowly because this thing gets hot very easily, and the rather short simple driptip doesnt protect your lips from the heat of the quite massive hot cap. Therefore I dont go under 0,3 Ohms, which is a bit high for me on a mechanical mod. ordered the ultem cap to make it a better experience. All in all another 22mm single coil rda with good flavor and some flaws.