shopping cart empty
EAdams76's Product Reviews
Sort:
Atomo 2 Style Mechanical Mod
Atomo 2 Style Mechanical Mod

EAdams76
Member

VERIFIED OWNER
  • JoinedMay 2013
  • Posts 8
  • Reviews 9
  • Kudos5
Overall   (4.5)
› Quality
› Value
1 of 1 people found the following review helpful
PROS
Quality build Nice threading Great switch
CONS
Had some sharp edges
Couldn't be happier at this price point. Been using only sub-ohm and haven't had any heating issues with the switch.Conductivity is good. Only issue I had was that some edges were sharp. Buffed them smooth with a Dremel. Will probably order another...
Reviewed on Was this review helpful to you? Yes / No

EAdams76
Member

VERIFIED OWNER
  • JoinedMay 2013
  • Posts 8
  • Reviews 9
  • Kudos5
Overall   (5.0)
› Quality
› Value
1 of 1 people found the following review helpful
PROS
Price and quality
Squeezed these in my vmod xl and have battery for days.. They're a tad long and barely fit in my xtar wp2 but, they do..
Reviewed on Was this review helpful to you? Yes / No
Stainless Steel + POM Hybrid 510 Drip Tip (5-Pack)
Stainless Steel + POM Hybrid 510 Drip Tip (5-Pack)

EAdams76
Member

VERIFIED OWNER
  • JoinedMay 2013
  • Posts 8
  • Reviews 9
  • Kudos5
Overall   (4.7)
› Quality
› Value
PROS
Blocks spitback
CONS
Needs slight modification
Needed a drip tip with spitback guard for one of my RDAs. Design gives great flavor but, because of coil proximity to drip tip and bottom airflow get more than the occasional spitback. Problem with most of these designs is that they "pool"after vaping for a bit. These did ever so slightly on the edge. If you press out the plastic insert and widen the holes enough that you eliminate the edge/lip, you'll eliminate any pooling and they'll work as intended without issues. They're great. No loss of flavor. Highly recommend with slight modification.
Reviewed on Was this review helpful to you? Yes / No
AX1 Styled RDA Rebuildable Dripping Atomizer
AX1 Styled RDA Rebuildable Dripping Atomizer

EAdams76
Member

VERIFIED OWNER
  • JoinedMay 2013
  • Posts 8
  • Reviews 9
  • Kudos5
Overall   (4.0)
› Quality
› Value
PROS
Leak proof Small Good flavor
CONS
Dripping runs into air inlets
Nice machining. I don't mind a tight draw and flavor is good. Built using the standard connections and an elongated coil attaching under the screws on the outer posts. Both worked well. Much easier using just the screws. Dripping sucks. Either they needed to lower the positive bridge or raise the air inlets. Juice runs into the air inlets because they're level to one another. Gurgles go away with a sharp draw, still annoying. One complete air inlet instead of 4 individual little ones would be better. The concept is really original and good but, unfinished and flawed. I still would purchase again though.
Reviewed on Was this review helpful to you? Yes / No
V3 Telescopic Mechanical Mod
V3 Telescopic Mechanical Mod

EAdams76
Member

VERIFIED OWNER
  • JoinedMay 2013
  • Posts 8
  • Reviews 9
  • Kudos5
Overall   (3.7)
› Quality
› Value
Almost returned mine. As another reviewer stated the button/firing pin unscrews. It's a bit of a hassle because it's continually loosening up and unless it's completely tight the locking bolt doesn't engage and turn it off. Needed some additional grinding around the edges of one of the tubes. Was uneven and a tad sharp. Other than that it works well and looks good.
Reviewed on Was this review helpful to you? Yes / No