Not a bad atomizer at all. Easy to build with low gauge wire. Use 6 turn 24 gauge Royal Wire on it, similar to Gplat. I could of gone to 20 gauge with no problems. One important thing is to take a small piece of coil wire, stick it down into the air holes and turn it around to ensure all is loose if there is leftovers from it being manufactured. I didn't find any but it is always better to be safe than sorry. Then wash it. The see through cap worked fine. I prefer the the other cap myself, very well made. Both can handle the heat just fine. Easy to build even though grub screws are used. I don't mind the grub screws as long as the post are thread properly and this atomizer it was. You get a good airflow and a good flavor from this one and the body handles the heat well. Buy it and you won't be sorry that you did. I can only speak for this model and not any other clones of this clone.