I haven't really formed an opinion of how it vapes. I put one build in it that I didn't like but I think that had more to do with the bad choice for my coil than the RDA. I haven't re-done it yet. So...
I can say that SXK did a really nice job with this clone, as they usually do. Great quality and excellent price.
I'm not a fan of how NoName Mods puts the o-ring inside-mounted in the cap. As with their other models, it can come out too easily and it's hard to put back in but they keep designing them this way. Be careful to bend back any excess wire after trimming it. Even the tiniest point from that can snag on that o-ring. I couldn't even see that point without magnification but I could feel it there.
It fit nicely on a Dripmod 60 and Frankenskull but it sat a little high on Pico Squeeze and Coppervape BF's shallow 510s. If you want to use it on these mods, try putting one or two of
SKU 5285900 underneath it or filing down the 510 positive pin. If your squonk mod has a springy 510 you should have no trouble.
It's tiny (18mm) and the drip tip seems
really tiny but I put another 510 drip tip on it and it looks and works well. Though tiny, the layout of the single-coil build deck allows for a good size coil if that's what you want in there. I'd avoid coils that can get too hot in such a small space with low airflow though. I think that's where I went wrong.
Post screws are M2.5 x 3mm Headless
SKU 3981606
Because it has bottom-air, you need to be careful not to over-squonk but the air intake holes are very small so not alot of juice escapes if you overdo it. It does have good drainage and excess juice draws back quickly so that's not really a con, just something to be aware of. After practicing with the cap off, I was able to get a feel for how hard I could squeeze the bottle. I probably could have done a better job of positioning the wick to keep juice away from the holes, too.
It is definitely geared for MTL vapers. They should be pleased with the airflow options. Even with the fully-open setting, airflow is through just 3 small (about 1.3mm) holes. There are settings to dial it down quite a bit further. The air is well directed to the coil.
Direct-Lung vapers might not like this one. I think they would be better with the NoLegal RDA with its choice of caps.