Thread Tools Rate This Thread
Login to rate this thread.
|
|
akay75
Member
- JoinedApr 2014
- Posts
14
- Reviews
8
- Kudos0
|
With Other Coil Heads?
can I use with other coil heads?
example: http://www.fasttech.com/products/1476404
|
|
CJPowers
Member
- JoinedApr 2014
- Posts
21
- Reviews
5
- Kudos7
|
These are the coils you want: https://www.fasttech.com/p/1604506
They fit the Protank 3, Mini Protank 3 and the Aerotank.
As for the coils in your link, I'm not sure. I think they do but I'm not 100% sure. I've only been buying the dual coil heads for my Protank 3.
Edited on 4/17/2014 at 6:17 AM. Reason:
|
|
akay75
Member
- JoinedApr 2014
- Posts
14
- Reviews
8
- Kudos0
|
@CJPowers
thanks.
I've ordered these:
Authentic Mini Protank 3 Dual Coil Clearomizer
Authentic Protank Clearomizer Coil Heads (5-Pack) SKU: 1476404
Coil Heads for Protank Clearomizer (5-Pack) SKU: 1479302
|
|
jeebus2002
Member
- JoinedFeb 2014
- Posts
88
- Reviews
0
- Kudos58
|
The protank 1 and 2 (and unitank and evod) use the same coil heads, the protank 3 and aero tank use dual coil heads that are different. I don't think the protank 1/2 heads fit.
|
|
CJPowers
Member
- JoinedApr 2014
- Posts
21
- Reviews
5
- Kudos7
|
+2
details
I was under the impression that the single coils for the Protank 1 & 2 did fit the Protank 3, but the dual coils for the PT3 etc didn't fit the older Protank models.
|
|
jombo53
Member
- JoinedDec 2013
- Posts
114
- Reviews
52
- Kudos42
|
+2
details
The coils for Evod, Pro, etc (single coil) work but I use 2 rubbers on the chimney because sometimes laying on side or upside down for periods of time will flood the airway and also may suck juice in. The only difference is the DC coils are taller so there is a gap where chimney goes into airway but they work just fine with cotton. I have several BDC kangers here and use old rebuilt single coils in em all np. You of course need the tall chimney on em. Same for Evod2, mini Pro3, etc
|
|
The_neck
Member
- JoinedDec 2013
- Posts
14
- Reviews
1
- Kudos1
|
As above said you can use a single coil with these but with two rubber grommets on top of one another, but also you can rebuild the duel coil heads, using NR-R-NR wick and wires available here if you use 2x 2.5 ohm wick and wire with a 2mm silica insulator between them your head shoukd come out at about 1.3 ohms. Just a bit of trial and error but that's the way I go, there's a nice short vid on YouTube http://youtu.be/dnRPJm4gCPY
|