shopping cart empty
WORLDWIDE FREE SHIPPING

setting
Login to post a new topic and to write a reply.
Thread Tools Rate This Thread


Search within thread:

Login to rate this thread.
#1 (permalink)      9/15/2015 10:38:34 AM US Central   quote/reply + tips
Bill6565
Member
  • JoinedFeb 2014
  • Posts 145
  • Reviews 74
  • Kudos25
+1 details
setting
1.) press the fire button many time till it ether shows power "on" or "off" wait a 5sec turn it back on again!

2.) press both - and + same time to adjust volt's or watt's switch between settings, press - lower it and + change higher settings

2.) see what the Ohm's be press + and hold till you can see what the Ohm reading be!

3.) Press and hold the minus key for the battery voltage.
tip #3 by: Sossij

display will not show-up when you fire the unit up only! if you change setting or like to see what the Ohm or power level of the battery are like. basic it flash on for a bit!
==========
btw i notice it save setting when change battery's out didn't have to reset settings
==========

**over all not a bad unit

Edited on 9/15/2015 at 11:28 AM. Reason:
#2 (permalink)      9/15/2015 11:07:29 AM US Central   quote/reply + tips
Avatar
Sossij
Member
  • JoinedMay 2013
  • Posts 5882
  • Reviews 0
  • Kudos5957
+1 details
Press and hold the minus key for the battery voltage.
"You quit cigarettes, you started vaping, and now you're Einstein"
#3 (permalink)      9/15/2015 11:19:41 AM US Central   quote/reply + tips
Bill6565
Member
  • JoinedFeb 2014
  • Posts 145
  • Reviews 74
  • Kudos25
thanks for that tip!
learn something new!
#4 (permalink)      10/30/2015 12:13:14 PM US Central   quote/reply + tips
Bill6565
Member
  • JoinedFeb 2014
  • Posts 145
  • Reviews 74
  • Kudos25
will i notice it can't handle sub-Ohm e-cig like 0.5-0.6 Ohm acts like the battery is dead when i try to use sub-ohm coil 0.6ohm on it. so basic it can handle 1.00 ohm's above good, but not below that line lol

i have another model (SKU 1921000) e-cig mod can handle sub-Ohm easy


Edited on 10/30/2015 at 12:15 PM. Reason: correction