shopping cart empty
For k100, 1.5 ohm?
Login to post a new topic and to write a reply.
Thread Tools Rate This Thread


Search within thread:

Login to rate this thread.
#1 (permalink)      8/23/2013 2:54:52 AM US Central   quote/reply + tips
thatgmc
Member
  • JoinedAug 2013
  • Posts 5
  • Reviews 1
  • Kudos1
For k100, 1.5 ohm?
Will this work for a k100 with a 1.0-1.5 ohm setup?
#2 (permalink)      8/23/2013 4:15:57 AM US Central   quote/reply + tips
Joeydc
Member
  • JoinedJul 2013
  • Posts 77
  • Reviews 31
  • Kudos29
I would never use them inside any mech mod without some sort of protection.
They are not High drain batteries.

But hey, maybe at 1.5 ohm its not that risky. I wouldn't do it.
#3 (permalink)      8/26/2013 6:15:01 PM US Central   quote/reply + tips
NurseJ
Member
  • JoinedAug 2013
  • Posts 501
  • Reviews 6
  • Kudos301
+1 details
Mr viking65 had said it could handle 3.2a so it should be able to handle as low as 1.3 ohms safely....but to be safe ask fasttech the real specs, and don't go below 1.5 just to be safe :)
#4 (permalink)      11/10/2013 4:40:06 AM US Central   quote/reply + tips
bibi2013
Member
  • JoinedNov 2013
  • Posts 3373
  • Reviews 100
  • Kudos2589
is there any definite statement, what cartomizers (or combination cartomizer/18350 battery) can be used (is ideal) with a

- 18350 - 1200mah battery (its "stronger", more vapor?) and
- what fasttech cartomizers (ohm etc) ?

i read somewhere, that no more than 2 ohm should be used, but the fasttechs seem much too long...
ideal would be the boge 510 (low resistance?)..

the k100 standard cartomizer seems to be some 40mm, in fact it could be the X8
the smoketech 2.5 ohm is too long (51.5mm)
the smoketech 2.0 ohm is even longer (56mm)

the cartomizer that comes in the k100 (X8?) seems pretty crap, most testers immediately dumped it...

Edited on 11/10/2013 at 4:41 AM. Reason:
Edited on 13/32/2013 at 13:61 PM. Reason: yes
#5 (permalink)      11/10/2013 4:48:18 AM US Central   quote/reply + tips
bibi2013
Member
  • JoinedNov 2013
  • Posts 3373
  • Reviews 100
  • Kudos2589
about Smoktech 2.5 ohm

viking65 wrote on another thread:

It takes 35mm cartos these are longer 51.5 mm so they are the xl (FT measure threads to in the length so you need to minus that) so it will stick 10mm higher then the drip shield witch will be ok I think (you will see a little black but will work)



but they have too high resistance (2.5 ohm) for low battery ampere (18350 - 1200mah)?


Edited on 11/10/2013 at 4:50 AM. Reason:
Edited on 13/32/2013 at 13:61 PM. Reason: yes